Frog Leap Torpedo Pac

1. Adjust pH level to 7.2 - 7.8.
2. Bring Free Available Chlorine (FAC) to 1.0 ppm using a chlorine shock. Follow manufacturer's label directions.
3. Stabilize pool with cyanuric acid stabilizer. Follow manufacturer's label directions.
4. To install pac: Take Frog Leap Infuzer cap off. Remove pac colored caps. Hold Pac so the open end faces down. Insert into Frog Leap Infuzer at the bottom. DO NOT FORCE. Replace Infuzer cap and set the control dial per the size and pump run time of your pool according to the chart in the manual included with the Frog Leap Anti-Bac Mineral Pac. Monitor chlorine level daily for the first week to determine the correct dial setting. Turn the control dial to the next higher setting to increase the FAC and turn it to the next lower setting to decrease the FAC. Check the FAC residual with Frog Strips and increase/decrease one setting per day until you achieve at least a 0.5 ppm. Do not enter the pool until the chlorine residual is at least 0.5 ppm.
5. Once you determine the proper setting for your pool, you do not have to re-adjust the setting under normal conditions. If conditions change (i.e. weather, rain, pool use, bather load, ect.) the control dial can be easily adjusted to increase or decrease the chlorine feed.
6. Superchlorinate if needed. Do not add shock treatment to the skimmer. Turn control dial to minimum or setting 0 before superchlorinating. Once desired FAC has been obtained, return the control dial to the normal operating setting.
7. Periodically check the pac and replace with a new one when empty. Do not attempt to open or refill this pac. DO NOT REUSE.

Thrichloro-s-Triazinetrione: 99%, Other Ingredients: 1%, Available Chlorine: 90%