Sun Floc & Clear

NOTE: Read entire label and use strictly in accordance with hazard warnings and directions.

For Cloudy Water

1. Shake Well Before Use!
2. Check filter and backwash or clean if necessary
3. Adjust pH to 7.5-8.0 for best results.
4. Use at a rate of 8 oz per 10,000 gallons.
5. Remove skimmer basket and any product in the skimmer. Pour this product slowly into skimmer with the pump on and filter valve in precirculate or whirlpool position. For filters without a recirculate: backwash, than with filter in filter position, dilute this product into large plastic pail of water and apply evenly over surface of pool. Replace skimmer basket after applying this product.
6. Allow pump to circulate water for 2 hours to distribute this product throughout the pool.
7. Shut off pump. Let this product settle debris to bottom while pool remains undissolved for 12 to 24 hours (usually overnight). Note: The greater the debris in the water, the faster this product works. For extremely cloudy pools (you cannot see the drain in the deep end of your pool) use a double dose.
8. Vacuum to waste all settled debris with filter in waste or drain mode. Note: settling may continue for several days if new debris is introduced by wind or rain. If so, vacuum to waste again. Do not vacuum debris through filter.
9. Backwash and clean filter and resume normal filter cycle.
10. Check pH and readjust if needed to 7.4-7.6.

For Water With Algae

1. This product will not kill algae, but facilitates the removal of dead algae after being treated.
2. After the algae treatment is complete per the algae treatment's label directions, follow steps 1-8 as previously stated under the Cloudy Water section above.