SpaGuard Soft Soak Spa Start-Up Kit

First Time Start-Up:

1. Fill Spa with water.
2. Once spa is filled, start equipment following manufacturers directions.
3. Balance spa water with SpaGuard Total Alkalinity Increaser and Calcium Hardness Increaser.  Follow label directions or recommendations from your SpaGuard computerized analysis.
4. Add the following amounts of SoftSoak products per 150 gallons of spa water:  Add 5 oz. of SoftSoak Spa Conditoner.  Add 1 oz. of SoftSoak Stain & Scale Control.  Add 3 oz. of SoftSoak Spa Shock. 
5. Circulate your water continuously for approximately 30 minutes with the blowers off.
6. Add 1 oz. SoftSoak Sanitizer per 150 gallons of spa water and circulate continuously again for approximately 30 minutes.
7. Using SoftSoak Spa Water Test Strips, check your SoftSoak Sanitizer level and pH. 
8. The sanitizer level should be between 30 and 50 ppm and the pH range should be 7.4.

Weekly Care:

1. Using SoftSoak Spa Water Test Strips, test pH, total alkalinity, calcium hardness and sanitizer levels of your spa.  Write down the results.
2. Add the following amounts of SoftSoak products per 150 gallons of spa water:  Add 1/4 oz. of SoftSoak Stain & Scale Control.  Add between 1-1/2 to 3 oz. of SoftSoak Spa Shock according to spa use rate.  If your spa is used 3 or more times per week, add 3 oz. per 150 gallons of spa water.
3. The SoftSoak Sanitizer Levels should be 30-50 ppm.  If sanitizer level is 15-3- ppm, add 1/2 oz. of SoftSoak Sanitizer per 150 gallons of spa water.  If sanitizer level is 0-15 ppm, add 1 oz. of SoftSoak Sanitizer per 150 gallons of spa water.
4. If pH is outside 7.4, adjust as needed with SpaGuard pH increaser or pH decreaser.

Monthly Care: 

1. Have your water tested by your SpaGuard SoftSoak Dealer. 
2. Chemically clean your filter with SoftSoak Filter Cleaner.

Every 2 to 3 Months:

1. Drain
2. Clean
3. Polish
4. Refill