|
SeaKlear Pool Particle Removal System
|
|
|
PoolGeek.com Price:
|
|
|
|
|
| Show All | Description | Specifications | Directions | Manufacturer Info | Reviews |
| SeaKlear Pool Particle Removal System is a patented, two-stage system proven to enhance filtration in pools, spas, and hot tubs. This product reduces water's turbidity and recovery time, especially during peak bather loads. Pool Particle Removal System is now EPA approved to effectively trap Cryptosporidium in the filter thereby reducing E. coli outbreak risk. It enhances filtration down to 0.5 micron. | |
Dosage
Stage 1: 4 oz. per 20,000 gal. Stage 2: 4 oz. per 20,000 gal. Frequency:
High Bather Load - Daily.
Medium Bather Load - 2-4 times per week.
Low Bather Load - Weekly.
|
Ingredients
A blend of bacteria traping chemicals.
|
Product Use
Use this product to trap algae, E. coli, Cryptosporidium and Giardia in the pools filter.
|
Directions
- Make sure the filter is clean and equipment is working properly.
- Using a time-metered pump or by hand, add PRS Stage 1 per the recommended dosage.
- 6 hours after adding Stage 1, add PRS Stage 2 per the recommended dosage, using a time-metered pump or by hand.
In Case of Accidental Fecal Release: - Evacuate the pool.
- Remove all visible fecal material possible.
- Follow local health department guidelines for proper disinfection.
- To trap remaining particles, Cryptosporidium, E. coli, and Giardia, treat the pool with PRS in the following manner:
- Add stage 1 by dispersing it throughout the pool at 4 oz. per 20,000 gallons.
- 30 Minutes after adding Stage 1, add Stage 2 at 4 oz. per 20,000 gallons.
- Do not add Stage 1 and Stage 2 at the same time.
- Monitor the filter pressure at regular intervals.
- Backwash the filter after proper CT disinfection value is achieved.
|
Reviews
|
|
|