ProTeam Power Magic Superoxidizer

Marcite or Concrete Pools:  1 lb. per 10,000 gallons of pool water.

Vinyl, Painted or Fiberglass Pools: 1 lb. per 10,000 gallons of pool water.

Preventative Treatment: 1 lb. per 10,000 gallons to prevent pool problems.

1. Always adjust pH between 7.2 and 7.4 prior to using this product. 
2. To oxidize the organic contamination which builds up in pool water, add 1 lb. of this product for every 10,000 gallons of water. 
3. Pre-dissolve the product in a clean plastic container of water, then sprinkle the solution into the pool.
4. Add this product at night or when the pool is not in use. 
5. Do not use the pool until the free chlorine residual had dropped below 3.0 ppm. as determined by using a test kit. 
6. This product should be used weekly during periods of heavy use or when water temperature are above 80 degrees and once every two weeks in residential pools receiving normal usage. 
7. Between treatments with this product, continue to maintain the proper water balance and sanitizer level in your pool as recommended on the label of your normal pool sanitizer.

Marcite or Concrete Pools: 

1. Broadcast over a large area at the deep end with pump running using 1 lb. per 10,000 gallons of pool water.

Vinyl, Painted or Fiberglass Pools:

1. At pool side, mix contents of 1 lb. into 3 gallons of pool water in plastic pail (do not add water to oxidizer). 
2. Allow 3 minutes to mix, then pour liquid into pool using 1 lb. per 10,000 gallons of pool water.

Preventative Treatment:

1. During periods of heavy rain or heavy swimming load, treat once per week using 1 lb. per 10,000 gallons to prevent pool problems.