Omni Algae Destroyer

1. Ensure all equipment is working properly.
2. Backwash the filter system following manufacturers directions. 
3. Adjust pH to between 7.2-7.6. 
4. In chlorinated systems, add stabilizer to establish a minimum stabilizer level of 30-40 ppm to reduce the degrading effects of sunlight upon the chlorine residual. 
5. Check for metals and if present add a stain and scale inhibitor to prevent staining of pool surface due to metals. 
6. Adjust chlorine residual residual to 1-3 ppm. 
7. When using other products as outlined in directions for this product, always follow directions on those products.
8. Before using this product, brush all suface clinging algae paying special attention to pool steps, ladder steps, and around skimmer and lights. 
9. At night or when the pool is not in use, broadcast this product directly into the water in the deep end of the pool with pump running. 
10. Use 2 pounds of the product per 10,000 gallons for medium to heavy algae growth and 1 pound per 10,000 gallons for light algae growth. 
11. To prevent possible damage to pool surface, use a pool brush to disperse any granules that may have settled to the bottom of the pool. 
12. Brush any remaining algae and clean/backwash filter. 
13. If algae is still visible, repeat treatment.

Light Algae Growth

1 pound per 10,000 gallons

Medium to Heavy Algae Growth

2 pounds per 10,000 gallons

Sodium dichloro-s-triazinetrione dihydrate - 99%

Inert Ingredients - 1%