|
New Water Cycler Pac 407C (Case of 3)
|
|
|
PoolGeek.com Price:
|
|
Product Brand: New Water
|
|
|
| New Water’s Cycler Pac 407C gives pool owners tired of constantly adding messy chlorine with a self-contained chlorine pack to manage their pools health, eliminating the need for hand feeding chlorine forever. Cycler Pac 407C’s design releases chlorine slowly and steadily to give you the optimal level of chlorine efficiently, using less chlorine while keeping your pool free of algae and other problems. This chlorine pack is designed for use in New Water’s 400 and 430 Series Cyclers. |  |
Dosage
Usage of this product will vary based on pool use, and weather. Keep free available chlorine between 1-1.5 ppm.
|
Ingredients
| Trichloro-s-Triazinetrione | 99% | | Other Ingredients | 1% | | Available Chlorine | 90% |
|
Product Use
Product Compatiblity:
New Water Cycler Feeder 400
New Water Cycler Feeder 430.
Prevail Cycler Feeder 5790 (same as 7 lb. cartridge)
Manufacturer's Number:
01-03-4073
|
Directions
- Adjust pH level to 7.2 -7.8.
- Bring Free Available Chlorine (FAC) residual to 1-1.5 ppm using a chlorine shock. Follow manufacturers label directions.
- Stabilize the pool with cyanuric acid stabilizer. Follow Manufacturers Label Directions.
- To Install Pac: Take New Water Cycler cap off. Remove pac cut offs. Hold pac so the open end faces down. Insert into New Water Cycler. The end of the pac must align with the key located inside the New Water Cycler at the bottom. Do not force. Replace New Water Cycler cap and set the control dial to appropriate setting. For a guideline, using a 13,500 gallon pool with a pump running 8 hours per day, begin with the control dial set on #3. For an 18,000 gallon pool, start at setting #4. To achieve the proper FAC, turn the control dial to the next higher setting to increase the FAC and the next higher setting to increase the FAC and turn it to the next lower setting to decrease the FAC. Operate the pool for 1 day. Check the FAC residual and increase/decrease one setting per day until you achieve 1-1.5 ppm. Pool should not be entered until the chlorine residual is 1-1.5 ppm.
- Once you have determined the proper setting for your pool, you should not have to re-adjust the setting under normal conditions. Should conditions change (i.e. weather, rain, pool use, bather load, etc.) the control dial can be easily adjusted to increase or decrease the chlorine feed.
- Super-chlorinate if needed. Do not add shock treatment to the skimmer. Turn control dial to minimum or setting #0 before super-chlorinating. Once desired FAC has been obtained, return the control dial to the normal operating setting.
- Periodically check the pac and replace with a new one when empty. Do not attempt to open or refill this pac. Do not reuse.
|
Reviews
|
|
|