Nature 2 Cense Divine Secrets

Read all directions and precautions before use.

Important: Always apply other spa chemicals separately and never combine products prior to addition to the spa. Cense is not a sanitizer. For routine disinfection, use an EPA registered product, such as Nature 2 Spa, according to the label's directions. When properly used, Cense will help your sanitizer work more efficiently. Keep this product dry. Use only clean utensils to dispense product. Never add water to the product/bottle. For spa start-up refer to Nature 2 Owners Manual.

Regular Use:

1. Add 1 tablespoon (aprox = 1.5 oz/or 16 grams) per 250 gallons (1000 liters) of water before each spa use.
2. Cast Cense into the spa while the spa is under continuous circulation with the cover off until the product is fully dissolved.
3. Test for MPS (monopersulfate) with Nature 2 Spa Test Strips (or equivalent) after allowing enough time for the product to be properly dissolved.
4. If the Nature 2 Test Strips (or equivalent) fail to indicate MPS levels in the 9-12 ppm range add another dose (1 tablespoon per 250 gallons) and retest before entering the spa.
5. After each spa use add 1 tablespoon of Cense to 250 gallons of water.
6. Allow time for the product to dissolve before turning off the spa jets. Test for pH, total alkalinity and total hardness using Nature 2 Spa Test Strips once a week. Adjust accordingly.

Note: Shock as needed when unpleasant odors or eye irritation occur, after heavy wind or rainstorms (if your spa was not covered), or if foam develops with 1.5 tablespoons of dichlor per 250 gallons to remedy problems which may occur when bather loads are high or when water appears hazy or dull.

Active Ingredients

Potassium Peroxymonopersulfate - 36%

Other Ingredients

54%

Active Oxygen - 3.8%