HTH Pace Dual Action 3 Inch Chlorinating Tabs

Method of Application:

Use in a floating dispenser, automatic chlorinator or feeder designed for this product, or simply place inside your skimmer.  Use in a new chlorinating device or any device which has previously contained only this product or whose active ingredient is trichloro-s-triazinetrione.  If placed in the skimmer, run the pump a minimum of 8 hours daily.

Water Balance:

1. To provide optimum product performance, swimmer comfort and crystal clear water always maintain a pH from 7.2-7.6, total alkalinity from 90-125 ppm, and calcium hardness above 200 ppm. 
2. Test frequently using a reliable test kit that measures all these ranges. 
3. Make any necessary adjustments promptly with the appropriate HTH Pool Care Products.

Routine Chlorination:

1. Add 1 tablet per 10,000 gallons of pool water every week or as often as needed to maintain a chlorine residual of 1-4 ppm. 
2. Follow method of application above. 
3. This dosage may vary depending upon swimmer load, water temperature, and other conditions. 
4. Pool should not be entered until the chlorine residual is 1-4 ppm as measured with a reliable test kit.

As a preventative treatment, you should shock your pool once per week to prevent pool problems.  In addition to weekly shock treatments, you should shock treat to remedy problems which may occur when swimmer loads are high, water appears hazy or cloudy, unpleasant odors or eye irritation occur, after heavy wind or rainstorms, or it algae does develop with resulting green color and slimy feel.

Shock Treatment:

1. Adjust pH to 7.2 to 7.4 with HTH Pace pH Plus or HTH Pace pH Minus per label instructions. 
2. Shock treat weekly with a product such as HTH Pace Super Chlorinator & Shock Treatment to kill bacteria, control algae, burn out organic material, and to keep water sparkling clear. 
3. Follow label directions.

Opening Your Pool:

1. Balance pool water, shock treat, and stabilize your pool using HTH Pace Stabilizer and Conditioner. 
2. Then follow routine chlorination directions.

Algae Control:

1. If pool surface develops algae or feels slippery, follw shock treatment directions. 
2. Immediately after shock treatment, thoroughly clean pool by scrubbing surface of algae growth, vacuum and cycle through filter. 
3. If necessary, repeat the procedure. 
4. Pool should not be entered until the chlorine residual is 1 to 4 ppm.

1 tablet per 10,000 gallons of pool water weekly.

Use this product to keep your pool free of bacteria, algae, and other organic contaminants that can compromise its appearance and safety.