Directions
How to make Filter Cleanse solution: Use a large plastic pail. Dissolve 1 lb. in 5 gallons of lukewarm water, stirring with a wooden stick until the solution turns dark red and the Filter Cleanse is totally dissolved. Determine the capacity of the filter tank by the manufacturers label and make enough solution to cover the elements or the sand. Compatible with all sanitizers including bromine, chlorine, salt water, ozone, minerals, and biguanide. How to use Filter Cleanse: -Cartridge filters and removable D. E. elements: Stop filtration and drain all water from filter. Remove elements and soak overnight in sufficient Filter Cleanse solution to cover. DO NOT USE GALVANIZED ALUMINUM OR PORCELAIN CONTAINER FOR SOAKING. Remove filter elements from solution; drain and rinse thoroughly with warm water until clear and replace in filter. Start pump and fill filter with clear water. -Sand filters and filters without removable elements: Backwash water. Drain water from filter and close drain vavle. Open filter top and pour premixed Filter Cleanse solution until the top of the sand is covered. (If top of filter is not removable, follow directions below.) Let stand overnight (12 hours). Backwash until water coming from backwash line is clear. Do not allow solution to get into pool. If top of filter cannot be removed, backwash filter then shut off pump and remove hair and lint pot cover. Drain filter. Turn on pump, making certain that handle is in backwash position and slowly pour Filter Cleanse solution into hair and lint pot with pump running. Do not allow pump to run dry. Continue running Filter Cleanse until sand or elements are covered. Shut off pump at once, leave in backwash position, and allow to stand overnight (12 hours). Backwash until water coming from backwash line is clear. Do not allow solution to get into pool. Start pump and fill filter with clear water.
|